We want to ensure that you get long-lasting satisfaction and pleasure from your
Do not use any abrasive sponges or scouring agents for cleaning. We also
advise you not to use cleaning agents containing solvent or acid, limescale
removers, household vinegar and cleaning agents with acetic acid in them. They
are aggressive to the surface – and will leave your fitting dull and scratched. As
the formulations of commercially available cleaning agents frequently change,
we cannot guarantee they will provide the gentle care our fitting deserves.
Clean the fitting with a little soap and a moist cloth only, then simply rinse off and
wipe dry. You can avoid lime spots by drying the fitting each time it is used. If
lime deposits do occur, remove them with GrohClean, our environment-friendly
cleaning liquid. GrohClean is specially formulated to clean the surface of our
fittings gently. GrohClean is available from your supplier.
Operation with unpressurized storage heaters is not possible.
• Flow pressure min. 0.5 bar – recommended 1 – 5 bar
• Operating pressure max.10 bar
• Test pressure 16 bar
• Flow rate at 3 bar flow pressure: approx. 12 l/min if static pressure is greater than 5 bar, fit pressure reducer.
Avoid major pressure differences between cold and hot water supply.
• Temperature hot water inlet: (maximum) 80 ° C
Recommended: (energy saving) 60 ° C
• Water connection cold – right
hot – from below
Never install shut-off valves in the outlet pipe (mixed water) downstream of any built-in mixer.
Prepare the wall for the installation. Prepare the holes for the wall mixer and slots for the pipes.
Install concealed mixer housing in wall and connect pipes, The cold water supply must be connected on the
right (marked blue on housing) and the hot water supply from below (marked red on housing), as viewed from the operating position. The installation depth of the finished surface of the wall must lie within the area (X) of the fitting template, By using a spirit level, align the mixer horizontally, vertically and parallel to the wall. Flush piping system prior and after installation of fitting thoroughly. Open cold and hot-water supply and check connections for watertightness!
Note: Do not remove the fitting templates before final
Remove the fitting template,
Shut off hot and cold water supply.
I. Install escutcheon and lever,
If the escutcheon will not slide far enough onto the cap,
you must additionally install an extension
(Prod.no.: 46 627 = 25mm).
II. Install spout.
1. Determine dimension “Y” from the leading edge of
built-in fitting housing to face of tiles.
2. Cut connection nipple (A) so that the installation
dimension is “Y” + 22mm.
3. Using an 12mm allen key, screw connection
nipple (A) into the built-in fitting housing until the
installation dimension is 10mm. Tighten spout (B)
from below using an 2,5mm allen key.
Open hot and cold water supply and check
connections for watertightness!
Check fitting for correct operation.